EVALUATION OF LAND FEASIBILITY FOR CONSTRUCTION OF THE ENTREPRENEURSHIP CENTER LABORATORY BUILDING OF STATE POLYTECHNIC OF LAMPUNG
DOI:
https://doi.org/10.51988/jtsc.v7i1.463Keywords:
land feasibility, topography, geotechnics, cut and fillAbstract
The construction of the Entrepreneurship Center Laboratory Building at Politeknik Negeri Lampung requires an initial technical assessment to ensure that site conditions adequately support the planned structure. This study aims to evaluate the feasibility of the building development based solely on land conditions, focusing on topography, soil characteristics, and earthwork requirements (cut and fill). The research employed a descriptive–analytical approach using secondary data from the Detail Engineering Design (DED), topographic maps, and Cone Penetration Test (CPT) results, supported by field observations for verification of existing conditions. The results indicate that the site elevation ranges from 144.41 to 146.22 m, with slope gradients between 2.6% and 3.6%, classifying the land as gently sloping and relatively stable for building construction. Geotechnical analysis based on CPT data shows that the soil bearing capacity is sufficient to support a bored pile foundation system. Earthwork analysis reveals a cut volume of 1,339 m³ and a fill volume of 107 m³, resulting in a surplus excavated material of 1,234 m³ that can be technically managed during construction. The overall land feasibility assessment, evaluated using a multi-criteria scoring method, yields a score of 4.30 out of 5.00, indicating that the site is feasible for the proposed building development when assessed from land condition aspects.
References
Arsyad, S. (2010). Konservasi Tanah dan air. In Konservasi Tanah dan air.
Direktur Jenderal Pengendalian Daerah Aliran Sungai Dan Hutan Lindung (2018). Petunjuk Teknis Penyusunan Data Spasial Lahan Kritis
Ginting, E. B., Haribowo, R., & Primantyo, A. H. (2024). Studi perbandingan perhitungan volume galian dan timbunan menggunakan data Total Station dan UAV. Jurnal Teknologi Dan Rekayasa Sumber Daya Air, 4(1), 616–626.
Kapoor, N., & Bansal, V. K. (2021). Spatial suitability assessment for planning infrastructure facilities at site level in hill areas. Journal of Urban Management, 10(2), 166–179.
Purwati, D. N. (2020). Pengukuran topografi untuk menghitung volume cut and fill pada perencanaan pembangunan perumahan di Km. 10 Kota Balikpapan. JUTATEKS (Jurnal Teknik), 4(1), 13–23.
Sersermudi, H. L., Tungka, A. E., & Tarore, R. C. (2022). Analisis Persebaran Lahan Kritis Di Kecamatan Lolak Kabupaten Bolaang Mongondow. Jurnal Spasial, 9(1).
Setiawan, A. (2023). Evaluasi daya dukung tanah menggunakan data sondir (Cone Penetration Test/CPT) untuk perancangan pondasi gedung kampus. Saintis Journal.
Shariatmadari, N., Karimian, M. H., & Salami, M. (2008). Bearing capacity estimation of shallow foundations using cone penetration test (CPT) results. Geotechnical Engineering Journal, 39(2), 45–56.
Sulistianto, D. (2024). Analisis daya dukung pondasi berdasarkan data uji sondir (CPT) untuk perencanaan pondasi dalam. Jurnal Teknologi Sipil (Poltekba).
Wahba, D., El-Bialy, M., & El-Sayed, S. (2024). Optimizing site selection for construction: Integrating GIS and multi-criteria decision making. ISPRS International Journal of Geo-Information, 14(1), 3.
Downloads
Published
Issue
Section
License
Copyright (c) 2026 Jurnal Teknik Sipil Cendekia (JTSC)

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.











